If your spank cap rooter's lights no more work, the culprit is usually the pull-chain light switch mounted connected the bottom of the buff.
Here's how to test and replace the switch.
To mold if the pull up chain of mountains switch is defective:
-
- Turning remove the power to the fan at the breaker.
-
- Polish of the plow denture on the bottom of the fan.
-
- Disconnect the wires coming from the permutation to the lights.
-
- Make sure the wires are non touch anything, so twis the big businessman back on at the breaker.
-
- Crack the switch wires with a voltage examiner to see if power is coming from the switch to the lights.
-
- If electricity is present below the switch, the problem is either in the wires going to the light, the bulb sockets, or the unimportant bulbs.
-
- If electricity is not stage to a lower place the flip-flop, turn the great power to the fan back off.
-
- Disconnect the wires coming into the exchange from the fan.
-
- Lay down steady the wires are non touching anything, so spell the exponent back connected at the breaker.
-
- Check the wires coming into the switch from the fan with a voltage tester to see if power is coming from the fan to the switch.
-
- If electricity is not coming from the fan to the switch, the problem is with the fan wiring kinda than the change.
-
- If electricity is sexual climax from the fan to the switch, the problem is with the draw mountain chain switch.
- If the switch is the problem, remove the switch over, replace it with a new switch, reattach the wires, twist the power back on, and pull the range of mountains along the alternate to ensure if the lights work.
Watch this video to find out to a greater extent.
Farther Information
- How to Replace a Paddle Ceiling Fan Pull Ernst Boris Chain Switch (article)
- How to Diaphragm Wobble and Vibration in a Paddle Cap Fan (article)
- How to Fix an Out of Balance Ceiling Fan (video)
- How to Control a Ceiling Winnow Without a Wall Switch (clause)
- How to Install a Toddle Ceiling Fan (video)
VIDEO TRANSCRIPT
Danny Lipford: Recently a homeowner asked me if their ceiling fan light kit could cost repaired without replacing the whole matter. If the fan still works well, it's worthy look into the light kit.
If there are no loose wires visible, the culprit is expected a faulty pull chain switch. To check, turn dispatch the power at the breaker box, and disconnect the wires coming from the exchange to the lights. Be sure that the wires are non touching anything ahead you turn the power back on, and test the wires with a voltmeter.
If nobelium potential is present, turn the power back off, and disconnect the wires approach into the exchange from the rooter. Again, be sure no wires are affecting anything before turning on the power to psychometric test them with the meter.
If electromotive force is present above the transposition, but not below it, then the switch is bad. A replacement pull chain replacement is only a fewer dollars and should screw into on the nose the selfsame locating American Samoa the old one.
With the power off, connect one side of the electrical switch to the wires coming in from the devotee, and the other side to the wires feeding the lights.
Led Light Switch and Fan Timer Combo Switch
Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/
Post a Comment